The Tachograph Emulator designed to work as a replacement for tachograph in the vehicle where the tachograph is no more necessary, but other electronic modules require signals generated by the tachograph. The emulator generates following signals:
- V imp – pins B6, B7, D3
- 4 imp/m – pin B8
- Zero speed signal – D8
- Via CAN: vehicle speed, distance traveled, date and time – pins A4, A8
- Or via k-line: distance traveled, date and time – PIN D7
Tachograph Emulator shipped prepared for your vehicle (don’t forget to provide necessary data required for additional programming, we will prepare Tachograph Emulator for your truck, you’ll get it ready to install).
Technical data
All signals are compatible with ISO 16844-1 standard
| Power supply | 12V or 24V |
|---|---|
| Current consumption | 40mA |
| „k” factor setting range | 4000 ÷ 64000 imp/km |
| Output power supply for speed sensor | 8V DC |
| Working temperature range | –40°C ÷ +85°C |
| Dimensions | 113 x 65 x 23 mm |
Connection
Plugs – A [white], B [yellow] and D [brown] should be connected to relevant sockets in the emulator.
| SOCKET & PIN NUMBER | FUNCTION | ADDITIONAL INFO |
|---|---|---|
| A1 | Power from battery | [30] |
| A3 | Ignition | [15] |
| A4 | CAN H | |
| A5 | Ground from battery | [31a] |
| A7 | CAN GND | |
| A8 | CAN L | |
| B1 | Power supply output | [+] |
| B2 | Power supply output | [-] |
| B3 | Signal from speed sensor | |
| B6 | V-impulse | |
| B7 | V-impulse | |
| B8 | 4 imp/m | |
| D3 | V-impulse | |
| D6 | V-impulse | |
| D7 | K-line | |
| D8 | Zero speed signal |
Tachograph Emulator product
-
Tachograph Emulator DTCO SIM CAN
Sale! $259 – $363 Select options This product has multiple variants. The options may be chosen on the product page
Attention!It’s illegal to use this equipment in several countries. You assume full responsibility for the use of the device. It’s your decision to use an tachograph emulator or not. We will not accept any liability for any consequences associated with usage of tachograph simulation devices.